pulling and checking pushrods?
04-29-2006, 01:07 PM
#1
Staging Lane
Thread Starter
Join Date: Feb 2005
Location: Baltimore
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
pulling and checking pushrods? im pretty sure i bent another pushrod 
...last time my car was under warranty so i didnt have 2 mess with it but this time i will. so how hard is it 2 pull and check ur pushrods? and what all has to be removed?
...last time my car was under warranty so i didnt have 2 mess with it but this time i will. so how hard is it 2 pull and check ur pushrods? and what all has to be removed? 
04-29-2006, 02:18 PM
#2
TECH Regular
iTrader: (14)
Join Date: Apr 2005
Location: okc, oklahoma
Posts: 400
Likes: 0
Received 0 Likes
on
0 Posts
pull your valve covers, and pull your rocker arms off, once your rockers are off your push rods are right there. nothing to it at all. You will have to tourque your rocker arms back down, so make sure you have a tourque wrench.
05-03-2006, 03:35 PM
#6
Teching In
Join Date: Dec 2005
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
SO that works for a 1999 z28 right? I only hear the tick tick tick sound when I am to low in a gear only. Does that mean i have a bent rod or rods????
Last edited by italianone; 05-03-2006 at 03:43 PM.
05-03-2006, 03:45 PM
#7
Teching In
Join Date: Dec 2005
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by '02 SLP#686
22ft/lbs - Should run them down to 0 lash and go to 22ft/lbs without going over 1.5 turns 
SO that works for a 1999 z28 right? I only hear the tick tick tick sound when I am to low in a gear only. Does that mean i have a bent rod or rods????
