does any1 know where the crank shaft position sensor is located.
i know it is near the starter.
there is a sensor right under the starter going into the oil pan but it may be the oil sensor.
this sensor goes every year.
i have had it replaced about 4 times.
figured i'd try for myself this time if i could.
any help is aprecated.

 

Yes, it's right over top of the starter on the block, not underneath on the oil pan. Not sure but I think you're going to have to remove the starter to get it out if you need to. It's reall easy though. Good luck!

 

So whats the sensor that goes in near the bottom of the oil pan on the passengers side?


.

 

that sensor is for the oil level sensor

 

What he said

 

yes you need to take the bolts out of the starter and let it hang to get to the crank sensor.

 

ok, looking past the starter i think i saw the right1. lil (looks like a 10 mm bolt holding down a tab that holds the sensor in?
also to take the starter out is it just those two bolts going upward from the bottom?

 

Yep, just one 10mm bolt that holds it in. The two bolts go in from the bottom and that's all that's needed. Just be carefull of the wires going to the starter selonoid and not to tear them.