Are 918's still safe for Torquer v2?
07-14-2006, 12:38 PM
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Dec 2004
Location: Rochester, NY
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
Are 918's still safe for Torquer v2? Running the torquer v2 232/234/112+2 .595 / .595 XE-R lobes.
I have a 3,000 mile old set of Ti retainers, comp 918s, hardened pushrods. I simply installed them, didn't do any measuring. Is there a way to adjust them or shim them? I have been reading about properly installing them and am curious what exactly this means.
Also if I do have to get the PRC Dual spring, can I reuse these Ti retainers?
I have a 3,000 mile old set of Ti retainers, comp 918s, hardened pushrods. I simply installed them, didn't do any measuring. Is there a way to adjust them or shim them? I have been reading about properly installing them and am curious what exactly this means.
Also if I do have to get the PRC Dual spring, can I reuse these Ti retainers?
07-14-2006, 01:14 PM
#3
On The Tree
Thread Starter
iTrader: (3)
Join Date: Dec 2004
Location: Rochester, NY
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by PREDATOR-Z
You'll be fine.
BTW the Tv2 is .595/.598
and no you cannot use 918 retainers with duals.
BTW the Tv2 is .595/.598
and no you cannot use 918 retainers with duals.
Should I be trying to measure at what height they are installed? Or not worry at 7000rpms
