1fstbird

iTrader: (19)

I am sending my PRC LS6 heads back to TSP and was wandering how much I should get them milled. I will be running the TR224 112lsa and want the most compression out of the motor without having to flycut. I am using the stock valves, and a shorter pushrod. The block is all stock. The chambers are 64cc. Thanks

orangeapeel

iTrader: (18)

Are you looking for a higher CR mill? I would say like .015 -.020. And still stay on the conservative side.

1fstbird

iTrader: (19)

I dont care about lower compression. The higher the better.

1fstbird

iTrader: (19)

Whats the max compression i can get out of the ls6 heads and still clear without flycutting.

orangeapeel

iTrader: (18)

Shot ya back with a PM.