hllywd

iTrader: (2)

Well the car is all tore apart and should have the stock cam out and the new one in yet tonight. Its a Comp cam XR273HR-12. 530 / 534 lift with 112 LSA. Also installing new springs, pushrods and timing assembly.

Cant wait till TnT next week at WIR.

Im also thinkin bout Camaro night at GLD on the 23rd I think.

Whos up for that? Or WIR?

DuronClocker

iTrader: (25)

Hmmm Camaro night sounds interesting. I might do that and go stay at MSOE for the night.

DaddySS

the 220 224 is a nice little setup, let us know how it goes.

hllywd

iTrader: (2)

Didnt get as far as we wanted.

Fratsit

iTrader: (1)

How far along are ya?? I am in the last stages of mine. Just finished installing the rockers and now need to mount the balancer and front cover.

Have fun with that AC condensor....I can send ya a pic of mine tied up at a very awkward position. Did not break, though.

I must have 75 pictures of this entire install.

R/

Frat

hllywd

iTrader: (2)

Still no further. Wont get to it till Sunday again.
What cam did you go with?
What are the numbers?

Fratsit

iTrader: (1)

I went with the Torquer V3. 231/234 .644/.598 111+1

Its advertised at .643 on the intake, my camcard says .644......not the it will make a difference. LOL

No numbers yet, today I install the headers and ORY and I am done. I had a nightmare last night that I did not get her dot to dot and it ate itself upon start-up If I had a dollar for everytime I checked and re-checked that sprocket alignment and rolled the engine over by hand I would have paid for the endeavor 10 times over.


R/

Frat

Beasst8

iTrader: (1)

Mines almost done. But I ran into a stuck crank bolt. It sucks and is going to have to be drilled out this week. Oh well, it all comes with modding cars.