Dyno #'s w/ FLP's and ASP Pulley
#1
TECH Resident
Thread Starter
Join Date: Nov 2001
Location: Richmond,Va
Posts: 808
Likes: 0
Received 0 Likes
on
0 Posts
Dyno #'s w/ FLP's and ASP Pulley
I dynoed on Saturday but i havent had a chance to get the pictures of the sheets up untill now....anyway here are a few pictures of dyno sheets comparing three pulls i made before headers and pulley and then three pulls after headers and pulley and the a comparison of my best pull from each sessions! Enjoy! Not sure what got me what but im assuming most of its from the headers and i gained a little from the pulley but who knows im happy none the less! Ohh if you cant really see em that good from right here check em out on my webshots page....http://community.webshots.com/user/extremez28
[ December 31, 2001: Message edited by: ExtremeZ28 ]</p>
[ December 31, 2001: Message edited by: ExtremeZ28 ]</p>
#5
TECH Resident
Thread Starter
Join Date: Nov 2001
Location: Richmond,Va
Posts: 808
Likes: 0
Received 0 Likes
on
0 Posts
Re: Dyno #'s w/ FLP's and ASP Pulley
the numbers were kind of hard to read there so if you cant really read em my best there was 337 HP and 354 TQ and the comparision to my old dyno was 320 HP and 332 TQ now setup to setup the old setup was just Whisper Lid and Loudmouth exhaust w/ freemods and no filter.....my new setup is Borla Catback wide open the FLP's with offroad pipes and the ASP pulley....let me dig up the A/F stuff maybe i can get that scanned too but from what they were telling me i was fine untill i started to get into upper RPMs and then i was getting a TAD rich....i have my Maf Translator set at 2% Rich on WOT....
#6
TECH Resident
Thread Starter
Join Date: Nov 2001
Location: Richmond,Va
Posts: 808
Likes: 0
Received 0 Likes
on
0 Posts
Re: Dyno #'s w/ FLP's and ASP Pulley
[quote]Originally posted by Trevor D:
<strong>Very nice gains! I saw right at the same with my FLP headers as well. FWIW, I didn't show any additional power on the dyno w/ the ASP crank pulley, but the engine does spin up faster. <img src="gr_stretch.gif" border="0"> </strong><hr></blockquote>
yer right on the engine spinning faster thing <img src="gr_grin.gif" border="0"> <img src="gr_grin.gif" border="0"> , ohh and heres a goofy pic of me holding my dyno sheet hahaha all proud of my new accomplishment <img src="gr_images/icons/cool.gif" border="0">
[ January 01, 2002: Message edited by: ExtremeZ28 ]</p>
<strong>Very nice gains! I saw right at the same with my FLP headers as well. FWIW, I didn't show any additional power on the dyno w/ the ASP crank pulley, but the engine does spin up faster. <img src="gr_stretch.gif" border="0"> </strong><hr></blockquote>
yer right on the engine spinning faster thing <img src="gr_grin.gif" border="0"> <img src="gr_grin.gif" border="0"> , ohh and heres a goofy pic of me holding my dyno sheet hahaha all proud of my new accomplishment <img src="gr_images/icons/cool.gif" border="0">
[ January 01, 2002: Message edited by: ExtremeZ28 ]</p>