What do you guys think of these flow #'s
Thread Starter
Staging Lane
Joined: Nov 2001
Posts: 87
Likes: 0
From: MI
What do you guys think of these flow #'s Lift | Int - Exh
.200 159.2 132.7
.300 212.3 165.9
.350 233.9 182.4
.400 248.8 197.4
.450 262.1 207.3
.500 272.0 217.3
.550 272.0 222.3
.600 296.6 225.6
These are done with stock bore and dont know anything else off the top of my head.
The low lift #'s i like, and i also know these would show higher or aybe lower on another flow bench. We all know how this works <img src="gr_stretch.gif" border="0">
But good? bad?
BTW i think that the .550 intake lift was just a type.. i think its actually 28x.xx
[ March 09, 2002: Message edited by: PhantomTA ]</p>
.200 159.2 132.7
.300 212.3 165.9
.350 233.9 182.4
.400 248.8 197.4
.450 262.1 207.3
.500 272.0 217.3
.550 272.0 222.3
.600 296.6 225.6
These are done with stock bore and dont know anything else off the top of my head.
The low lift #'s i like, and i also know these would show higher or aybe lower on another flow bench. We all know how this works <img src="gr_stretch.gif" border="0">
But good? bad?
BTW i think that the .550 intake lift was just a type.. i think its actually 28x.xx
[ March 09, 2002: Message edited by: PhantomTA ]</p>
TECH Addict
Joined: Dec 2001
Posts: 2,298
Likes: 2
From: new england
Re: What do you guys think of these flow #'s These look like good numbers to me,stage 2 with stock valves? Anyway most important is your increase over stock flow, did you test before port work? If your port volumes artent very large i cant see why these heads wouldnt perform very well. <img src="gr_images/icons/cool.gif" border="0">