Extrude Hone- opinions?

Reply Subscribe

Thread Tools

Search this Thread

Jun 30, 2002 | 11:44 AM

Mr. B

Thread Starter

11 Second Club

iTrader: (1)

Joined: Feb 2002

Posts: 3,934

Likes: 0

From: NY

Extrude Hone- opinions?

I know that SVT Fords (Contours) have had this done.. perhaps some Cobra's.. any input about this with the LS1 Heads, Holley Intake, etc?

http://extrudehone.com/automotiveaftr.html

http://extrudehone.com/pwrfloprice.html

http://extrudehone.com/jpg/autobot.jpg

Jul 1, 2002 | 08:23 AM

Ragtop 99

TECH Senior Member

iTrader: (7)

Joined: Nov 2001

Posts: 9,491

Likes: 1

From: Bethesda, MD

Re: Extrude Hone- opinions?

The process is very expensive, so it will be far down your mod list. Also, since the LS1/LS6 intakes are plastic, I doubt that the process works with it.

The holley intake is an unproven mod (compared with a LS6 intake) in my book and unless you have everything else probably should not be on your shopping list.

Jul 1, 2002 | 10:59 AM

SIR

Launching!

Joined: Nov 2001

Posts: 247

Likes: 0

From: Chicago

Re: Extrude Hone- opinions?

I think I was quoted $600+ for them to extrude hone the Holley. So basically they can shove it. Total absolute **** raping by John Holmes at that price.

Jul 1, 2002 | 04:38 PM

AlonzoVersion 1.0

TECH Addict

Joined: Dec 2001

Posts: 2,340

Likes: 0

From: Fort Worth,TX

Re: Extrude Hone- opinions?

You might want to give total engine airflow a call sense they are a sponsor oh and dont email them they wont respond go figure but they can do porting for you.I am sure they are a lot cheaper than Extrude rape in the booty.