What is the thread size on ASP pulley puller holes?
#1
TECH Enthusiast
Thread Starter
Join Date: Nov 2001
Location: Orange, TX
Posts: 526
Likes: 0
Received 0 Likes
on
0 Posts
What is the thread size on ASP pulley puller holes?
I'm ready to pull my balancer and can't figure out what size the thread size is on my ASP pulley puller holes.
5/16 coarse and 8mm both go in a short ways and then seem to bind. I'm being very cautious since it's aluminum.
Anyone know the size?
5/16 coarse and 8mm both go in a short ways and then seem to bind. I'm being very cautious since it's aluminum.
Anyone know the size?
#4
TECH Enthusiast
Thread Starter
Join Date: Nov 2001
Location: Orange, TX
Posts: 526
Likes: 0
Received 0 Likes
on
0 Posts
Re: What is the thread size on ASP pulley puller holes?
Not yet. I had to stop last night for a friend's anniversary party.
I have it ready to pull the cam out. I'm going out to the shop now to finish it up right now.
I have it ready to pull the cam out. I'm going out to the shop now to finish it up right now.