Reading through the comp cams install guide......
#1
TECH Senior Member
Thread Starter
Join Date: Nov 2001
Location: Chi-Town, IL
Posts: 11,603
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech20year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I am going to buy a set of MTI stage 2 heads this week if all goes well....I am running an "X1" cam with these heads...I was reading through the instructions and it says if you are running double valvesprings (which these heads have) that you should remove the inner spring for proper break in...
Is this completely necessary??
Is this completely necessary??
#3
TECH Addict
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Not necessary that procedure is for flat tappet cams not roller cams. <img border="0" title="" alt="[Wink]" src="gr_images/icons/wink.gif" />
#4
TECH Senior Member
Thread Starter
Join Date: Nov 2001
Location: Chi-Town, IL
Posts: 11,603
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech20year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I was a litte confused reading that.... <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />