? on a .581 lift
Thread Starter
10 Second Club
iTrader: (5)
Joined: Nov 2001
Posts: 3,412
Likes: 0
From: Cali/Bay Area
? on a .581 lift Will a .581 lift be ok on a stock bottom end with a 10.5-11.0 CR? What would be the safest lift possible?
Dan
<small>[ September 23, 2002, 11:13 AM: Message edited by: DanZ28 ]</small>
Dan
<small>[ September 23, 2002, 11:13 AM: Message edited by: DanZ28 ]</small>
Teching In
Joined: Jan 2002
Posts: 18
Likes: 0
From: Big D
Re: ? on a .581 lift should be fine. Im putting a .591lift cam on mine in the next month. I got double valve springs for the hight lift. Might wana check into some rev1116 double springs for that high lift.
Thread Starter
10 Second Club
iTrader: (5)
Joined: Nov 2001
Posts: 3,412
Likes: 0
From: Cali/Bay Area
Re: ? on a .581 lift Thanks again for your input guys. I did expect some more input with the amount of people that post on this board and their knowledge of these engines, just not in their circle I guess...
Dan
Dan
