New Dyno Numbers
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
New Dyno Numbers Previously I dynoed 375HP 356TQ
since then I added a whisper Lid,Tbyrne MAF ends and 4:10 gears
I hit 365HP dont know the TQ. SO we decided to open the cutout finally and see what we got.
well 385HP and 367TQ not 400 like I wanted. I still need a TB and a MAF we'll see if that helps. my A/F was at 13.0 so were good there. I had massive blow by though I think its time for a piston and ring job.
Lets hope I can creep into the 11's tomorrow.
Marco
since then I added a whisper Lid,Tbyrne MAF ends and 4:10 gears
I hit 365HP dont know the TQ. SO we decided to open the cutout finally and see what we got.
well 385HP and 367TQ not 400 like I wanted. I still need a TB and a MAF we'll see if that helps. my A/F was at 13.0 so were good there. I had massive blow by though I think its time for a piston and ring job.
Lets hope I can creep into the 11's tomorrow.
Marco
Thread Starter
TECH Junkie
iTrader: (12)
Joined: Jun 2002
Posts: 3,151
Likes: 0
From: Fall River, MA
Re: New Dyno Numbers My guess is I need rings I ran the car on like 4 Cylinders for too long.I'm not gonna stress about it right now but I guess I should see what my options are for a bottom end.
