daniel6718

iTrader: (36)

anyone else have this problem? they are resting on the headers. i have to jack up the motor slightly to get the sterring knuckle on. I think if it goes up 1/4 inch it would clear...any ideas? what are my options on fixing it?
replace motor mounts with poly ones? (where to get these)
washers between the motor mounts/k member, motor/motor mounts???
anything else?

im using pa racing k member and dynaflow longtubes

onecamaro1

Althought i don't have dynaflow, i had to grind the head off the steering knuckle bolt "just to flatten it some". Mine did not fully rest on the shaft.

slow trap

iTrader: (22)

i modified my steering shaft by taking it off,cutting out a 2" section and welding in a smaller,solid rod.but it helps to work in a machine shop and also have welding equipment around.poly mounts may be the way to go.

daniel6718

iTrader: (36)

do they typically raise the motor? any other ideas?

its not hitting the bolt or anything, its hitting the shaft

daniel6718

iTrader: (36)

ttttt

daniel6718

iTrader: (36)

ttt again, anyone know where i can get poly motor mounts? and is there a better way to raise the motor besides washers