Please help.

Reply Subscribe

Thread Tools

Search this Thread

Jun 9, 2007 | 11:30 AM

NotthisSS

Thread Starter

Staging Lane

iTrader: (3)

Joined: Apr 2006

Posts: 80

Likes: 0

From: Yukon, Ok

Please help.

I just recently did a header install on my 2000 trans am.. i have not had it tuned yet.. i have been experiencing one major problem...the car alot of times will not accelerate when i give it gas and then when i slam it it kicks in and runs fine at WOT. but if i start driving regular again it start to cut out again..any ideas or suggestions? i have replaced the front 02 sensors and spark plugs but not spark plug wires

Jun 9, 2007 | 12:05 PM

2formulas

On The Tree

iTrader: (2)

Joined: Jan 2004

Posts: 134

Likes: 0

From: San Diego, CA

are you sure your plug wires are on the plugs

did you take any vac stuff off that might be causing a vac leak

Jun 9, 2007 | 12:06 PM

2formulas

On The Tree

iTrader: (2)

Joined: Jan 2004

Posts: 134

Likes: 0

From: San Diego, CA

make sure you didnt crack a plug when you put your headers in. most people take the plugs out for a header swap then replace the plugs with new ones if the olds are stockers.

Jun 9, 2007 | 01:02 PM

NotthisSS

Thread Starter

Staging Lane

iTrader: (3)

Joined: Apr 2006

Posts: 80

Likes: 0

From: Yukon, Ok

i put new plugs in after the install... i did have to undo vaccum crap though... i took off the egr but hooked it back up... the only thing is i got race style headers so they arent going into nething..