Installing engine....with or without headers?
Thread Starter
7 Second Club
iTrader: (11)
Joined: Jul 2002
Posts: 8,758
Likes: 9
From: Port Tobacco, MD
Installing engine....with or without headers? I am getting ready to install my motor in my 99 corvette and wondering if I should go ahead and bolt the headers, coil packs and the other little stuff? Should I bolt them up outside or inside the car?
Phillip
Phillip
TECH Apprentice
Joined: Oct 2002
Posts: 310
Likes: 0
From: san Antonio
Re: Installing engine....with or without headers? Well if I was installing a motor in my 99 TA and was going in from the top I would not install everything, but if you are going at it from the bottom...I would attach everything except the hoses and the wiring harness......good luck
Re: Installing engine....with or without headers? Install the block and bolt the heads on later. That is how I took amine out and how I am going to put it back in. My tranny is still in place and it is easy to bolt it to the tranny this way.
TECH Addict
Joined: Nov 2001
Posts: 2,556
Likes: 0
From: Nawf Carolina
Re: Installing engine....with or without headers? and headers go on *easy* when the heads aren't bolted down, just slide in the headers, set the heads on, then bolt down the heads and put on the headers
J.
J.
