ScreaminDemon

Hey Brian! I haven't taken pics of my block for you yet, it's too humid here in Memphis to even want to work on the vette. These heads sound great, might have to reconsider on any trade for my darton 434 block?

69_YENKO

iTrader: (16)

1,900$ for the as cast head that flows well, not bad

what does the full CNC'd version cost?

sschkade

iTrader: (7)

this post was from 2007, what ever happened to these heads?! are they out?

69_YENKO

iTrader: (16)

LOL, good catch. this is over 7months old, I just looked at the guy above me who posted today and replied thinking this was a new thread.

SOMbitch

iTrader: (8)

Yes the are out. I had flow #'s from TFS at one point. Call TEA about them.

69 Yenko, the cnc"ed ones where $2400 last I checked.

69_YENKO

iTrader: (16)

Thanks

Midnight02

iTrader: (8)

It would be worthwhile to go searching around the Dyno Results section to get a bit more information on these heads. Vengeance has installed a few sets of these and they've pulled some ridiculous numbers on the dyno.

I strongly considered going with these for my head swap, however I opted to buy the PRCs and use the rest of the cash for a N2O setup.

Ron@Vengeance

iTrader: (51)

These heads are readily available. They deliver the power as promised!!!! If anyone would like more info feel free to give me a call.