stock heads, what cam?
Thread Starter
TECH Regular
Joined: Jul 2005
Posts: 423
Likes: 0
From: Lombard,IL
i plan on getting new springs and pushrods as well. i was also lookin at the ms3 and ms4 but i think they are just too big for stock casting heads. i dont want a cam thats peak is at like 6500 thats too high to me for a stock bottom end. i know it has been done. i also dont want something that is all power from like 5k and up. thats why i have been looking at cams that are just a bit smaller then the both of those.
Thread Starter
TECH Regular
Joined: Jul 2005
Posts: 423
Likes: 0
From: Lombard,IL
i am gonna drive it on the street, dont get me wrong, its just not gonna be drivin everyday. im basically looking for a cam that would match perfect with stock, nuthing thats to big that the heads wont flow enough and i wont be able to get the full potential out the cam.
Thread Starter
TECH Regular
Joined: Jul 2005
Posts: 423
Likes: 0
From: Lombard,IL
i plan a going with a yank ss3600 or the ss4000 depending on what cam i go with. im not worried if the trans goes, because i dont live far from flt and thats where im gettin the new trans from. thanks again for all the input, keep the inputs coming!
I ran a 233/233 595/595 112 with bolt ons and stock heads and made 416 rwhp..and the car was a dailey driver ... I put over 40,000 miles on it in that configuration ... your cam is very similar .. you will need a good tune to make it right ..
