6.0 head and valve spring?
#1
TECH Regular
Thread Starter
iTrader: (19)
Join Date: Feb 2006
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
6.0 head and valve spring?
Hey guys I got a 3 angle valve job on my 6.0 heads,and my springs installed they are patriot gold recommended install height is 1.800 and mine are 1.746 is this going to be a problem?My seat psi is 158 and 390 open,is my seat psi too high? thanks
#5
10 Second Club
iTrader: (4)
Join Date: Oct 2006
Location: wisconsin
Posts: 855
Likes: 0
Received 0 Likes
on
0 Posts
i would have to say no do not try it set up that way,, those springs are rated for .650 but others say when measured .620" is the max lift they should be used for,,, since you have them installed .054" less than the factory 1.800".
so if you take your cam .584" + the .054" = .638" actuall lift applied to the spring
if you set them up at 1.800" you would be fine
so if you take your cam .584" + the .054" = .638" actuall lift applied to the spring
if you set them up at 1.800" you would be fine
#7
Staging Lane
iTrader: (4)
Join Date: Aug 2005
Location: Mississippi
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
You can get retainers or locks that can give you .050 or more installed height. I'd call Patriot and ask what they recommend. I'd had machinest' sink the valves to get correct installed height >>>>>> BAD move....