Cylinder Rust And Honing
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Sep 2007
Location: Portland OR
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Cylinder Rust And Honing
Hey all, a while ago I picked up a 5.3 block for really cheap. The cylinder walls have a bit of rust on them. I have already put a light coat of grease to stop any further rusting
I would like to just hone them and use my 5.3 pistons with new rings, how far can I go? And just to make sure if it is too much to fix with just a hone I can just bore it to accept stock 5.7 pistons out of an ls1 correct?
I would like to just hone them and use my 5.3 pistons with new rings, how far can I go? And just to make sure if it is too much to fix with just a hone I can just bore it to accept stock 5.7 pistons out of an ls1 correct?