LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Pushrod Question

Thread Tools
 
Search this Thread
 
Old Feb 18, 2008 | 05:47 PM
Share
  #1  
jpeach's Avatar
jpeach
Thread Starter
Teching In
iTrader: (1)
 
Joined: Oct 2007
Posts: 34
Likes: 0
From: DFW
Default Pushrod Question
I'm doing a head/cam swap on a '98 A4. The new cam is a Comp 228/228 588/588 /112 lsa. The heads are stock milled .030. What length pushrods will I need?
Reply
0
Old Feb 18, 2008 | 11:30 PM
Share
  #2  
LS6_Silverado's Avatar
LS6_Silverado
Staging Lane
iTrader: (7)
 
Joined: Feb 2008
Posts: 79
Likes: 0
From: Gainesville, FL
Default
Well i would say stock pushrods are 7.400... so 7.400 - .030 = 7.370, But you should just use a pushrod length checker anyways to just be safe.
Reply
0
Old Feb 19, 2008 | 08:59 PM
Share
  #3  
jpeach's Avatar
jpeach
Thread Starter
Teching In
iTrader: (1)
 
Joined: Oct 2007
Posts: 34
Likes: 0
From: DFW
Default
Does everyone agree? What if I just went with a 7.350; which I have a set of,,,
Would it be too far off?
Reply
0
Old Feb 19, 2008 | 10:04 PM
Share
  #4  
Grimes's Avatar
Grimes
TECH Addict
iTrader: (3)
 
Joined: Mar 2003
Posts: 2,636
Likes: 2
From: Northern NJ
Default
I think you are going to come up a little short with the 7.350, but get a checker like everyone said.
Reply
0
Back to Subforum
Generation III Internal Engine
View Next Unread
Oil Pump???




Advanced Search

All times are GMT -5. The time now is 08:57 PM.