LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

P0300 after pushrod install???

Thread Tools
 
Search this Thread
 
Old 04-20-2008 | 05:36 PM
  #1  
lcars's Avatar
lcars
Thread Starter
Staging Lane
 
Joined: Mar 2008
Posts: 89
Likes: 0
From: Michigan
Default P0300 after pushrod install???
I just installed new pushrods yesterday. Car seems to run fine but at low RPM it sounds like its missing or maybe an exhaust leak. SES light is still on after installing the pushrods. It is code P0300. What could it be?
Reply Like
Old 04-20-2008 | 08:25 PM
  #2  
lcars's Avatar
lcars
Thread Starter
Staging Lane
 
Joined: Mar 2008
Posts: 89
Likes: 0
From: Michigan
Default
Now my SES light has turned off. I don't know whats going on now. Think maybe the PCM needed to adjust or something????????????????????
Reply Like
Old 04-21-2008 | 10:55 AM
  #3  
lcars's Avatar
lcars
Thread Starter
Staging Lane
 
Joined: Mar 2008
Posts: 89
Likes: 0
From: Michigan
Default
Ttt!!!!
Reply Like
Old 04-21-2008 | 11:22 AM
  #4  
TaterSS's Avatar
TaterSS
Teching In
 
Joined: Apr 2008
Posts: 45
Likes: 1
From: Franklin, Wis
Default
P0300 is a Multiple Cylinder misfire, Is the engine still running rough? If not I wouldnt worry about it.
Reply Like
Old 04-21-2008 | 11:23 AM
  #5  
lcars's Avatar
lcars
Thread Starter
Staging Lane
 
Joined: Mar 2008
Posts: 89
Likes: 0
From: Michigan
Default
Engine seems to run fine now after the light went out and even before while it was on.
Reply Like
Tags
Back to Subforum
Generation III Internal Engine
View Next Unread
engine assy




Advanced Search

All times are GMT -5. The time now is 05:55 AM.