JASON 77

iTrader: (22)

If i was to use a MS3/PRC 5.3 2.5 heads with a LS6 intake? HP or 1/4 times

What about a MS4 and LS6 heads from PRC and can you use the LS6 intake with this?

Both setup's would be upgraded to afast 90/90 eventually. Really would like to be around the low 11's high 10's.

current mods are LT's, true duals from TSP, LID, Vigilante stall, 9 inch with 4.11's on 325 50 15 DR's.

thanks

~Jason

TransAmcoupe98

iTrader: (10)

First you need to address your bottom end and valvetrain beforehand. Such as rod bolts, and while you there, rods and pistons etc... Then your valvetrain...valve springs, pushrods, etc...Then, your tranny.

JASON 77

iTrader: (22)

trans is already done, valve train will be with the heads when purchased. not opening up the bottom end just yet, want to push it harder.