tr224 cam and 241 heads mill?
#1
tr224 cam and 241 heads mill?
So i'm going to be putting in a tr224 and a fresh set of 241 heads. I want to mill these heads, just wondering what would be good to take off .030? I dont want to mess with fly cutting. Also will I need shorter pushrods than the 7.4's i've got . Any info is appreciated.
#4
I went with 241 heads milled 0.030" with 7.4" rods with no issues on a previous motor but different camshaft. CR was around 10.8. 62cc heads.
TR told me no PTV issues with their TR224 and 0.030" milled 241 heads.
People will tell you use a pushrod length checker to measure because every engine is different.
TR told me no PTV issues with their TR224 and 0.030" milled 241 heads.
People will tell you use a pushrod length checker to measure because every engine is different.
Last edited by bluecamaroz28; 06-05-2008 at 02:15 AM.