LQ4 setup
Thread Starter
10 Second Club
Joined: Jun 2004
Posts: 289
Likes: 0
From: Choctaw, OK
LQ4 setup Well guys looking to see what your guys think this motor will make/run. Main factor being this is going in a 2700 or so lbs mustang...
Final Combo will be a 6.0 LQ4 short block, Texas speed 228R cam, 853 casting heads ported very well flowing over 300cfm and milled .048" putting the compression somewhere in the 11.0-12.00 range I think, Vic Jr. intake with a ProForm 850 on top. A 10" Yank 4000 race converter to go along with the built TH400 and trans brake..
Whats everyone think..yes I know cam is small but heads don't allow anything bigger on stock shortblock...
Final Combo will be a 6.0 LQ4 short block, Texas speed 228R cam, 853 casting heads ported very well flowing over 300cfm and milled .048" putting the compression somewhere in the 11.0-12.00 range I think, Vic Jr. intake with a ProForm 850 on top. A 10" Yank 4000 race converter to go along with the built TH400 and trans brake..
Whats everyone think..yes I know cam is small but heads don't allow anything bigger on stock shortblock...
I've got somewhat of a close setup to that...
LQ4 6.0 364c.i.
Texas Speed 224R cam
11.2:1 Compression Ratio
59cc AFR 205 heads
BBK Intake manifold
Full Exhaust
Lid+K&N
few other small mods...
making 446/416
dyno graph in sig...
LQ4 6.0 364c.i.
Texas Speed 224R cam
11.2:1 Compression Ratio
59cc AFR 205 heads
BBK Intake manifold
Full Exhaust
Lid+K&N
few other small mods...
making 446/416
dyno graph in sig...
