hey guys i just picked up a 99 ls1 motorset and t56 out of a camaro the other day.

this is going into my nissan 240sx drift car.

right now while the engine is out we are going to do a ls6 modded oil pump, and an oil accumulator and also do a cam, springs, retainers and push rods.

i was looking at the tsp cam kits and i just cant decide on a cam

im keeping the bottom end stock for now so i want to be able to rev it reliably so i think im going to get the rev limiter set at 6500? sound about right?

now as far as cams go the car needs a lot of mid range and some up top, i want to make power all the way to my redline so i dont want to go too small, but at the same time i dont want to go way too big that i want make enough midrange where i want it.

i was looking at the 233/239
the ms3 and ms4

power goals for the car NA are around 400whp

 

You should be more worried about getting ARP rod bolts

 

ok sweet well ill put in some arp rod bolts while im at it too, what about the cam choices?

 

do the 233/239 I ran that cam for awhile and loved it, seemed like power exploded over 3k rpm.

 

you guys thinkin the ms3 or 4 too big for my plans for the car then?

 

btw this car is not my daily lol its a fully caged track drift car, and the rear end gear is a 4.08