Fitment issue with new LS3 int
Fitment issue with new LS3 int Got a new OEM LS3 int ported with TSP ported L92/ls3 heads. Int was off about 16th. I'm not sure if the porting did it since the floor was lowered. It did thread on with some work.
Check the pic.
Thoughts...
Check the pic.
Thoughts...
Ok a decent amount of views and no one's seen this... I've pulled the manifold off a couple times just to confirm and the one side always lines up.
Last edited by RyanSws6; Aug 16, 2009 at 10:12 PM.
Yeah both heads were milled to come up with 66cc and cometic .030s. Still though why would one head fit and line up perfect and the other side is off? This is just crazy. They both looked the same and bolted on fine.
I found the issue, there is a plastic pin on the right under side of the intake. I assume with the milling the pin location moved and made it tough to bolt on. Since its plastic I cut it off and the int bolts on fine.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
