is it possible to delete dbw for cable
is it possible to delete dbw for cable Just picked up a 2008 6.2 and is going into a foxbody and was wondering if I can ditch the dbw for a cable style throttle body or if its even possible...or what would be the next easiest way to run in a swap....thanks...
Was doing research but just couldn't find the answers i needed so i would be able to use the stock harness and computer ???? Just delete out dbw in tune..and run a tb that allows a cable to be ran...
Teching In
Joined: Jun 2009
Posts: 45
Likes: 0
+closed to open loop transition will be screwed as it wont see the TPS
+traction control wont work
+ETC rpm limiting wont work
+again, should be open loop SD tune only
but idle - the main question
Later ecus have no provision for IAC.
You would need an ecu that has IAC capability and runs a 58x crank reluctor. Or get a 24 to 58x converter and use a 24x ecu.
By far the easiest would be get the dbw pedal.
You would need an ecu that has IAC capability and runs a 58x crank reluctor. Or get a 24 to 58x converter and use a 24x ecu.
By far the easiest would be get the dbw pedal.
On The Tree
Joined: Jun 2005
Posts: 118
Likes: 0
From: Fort Worth, TX
Why not just run the DBW setup? It's really easy to use and if you can do an engine swap I'm sure you can figure out how to mount a pedal. I'm running the stock DBW setup in my RX7 and it works great. Most people don't even realize it's electric after they drive it, at least until they stare under the hood for a minute or so.
