Removing stock ls1 headers swap with JBA shorty headers HELP
04-14-2013 | 11:12 AM
#1
Thread Starter
Teching In
Joined: Jun 2012
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Removing stock ls1 headers swap with JBA shorty headers HELP Ok I am new to this so I do not know if I am doing this right so bare with me
I took my stock headers off, and replaced them with JBA shorty headers, and on the Drivers side of the head there is one spot that had a peg in the head instead of a bolt,now I can not seal that part of the header the car is 100% stock before I touch it so
My question is now I have a small exhaust leak in that area
, How do I remove the peg 
??????
ANY HELP
I took my stock headers off, and replaced them with JBA shorty headers, and on the Drivers side of the head there is one spot that had a peg in the head instead of a bolt,now I can not seal that part of the header the car is 100% stock before I touch it so
My question is now I have a small exhaust leak in that area
, How do I remove the peg ??????ANY HELP
04-25-2013 | 04:51 PM
#3
Could you may be talking about the Coolant Temp Sensor....thats the only thing that i can think of thats on the drivers side head thats by the headers.......
