VRSenator065

Hi all, santa brought me an Auto Meter oil pressure gauge I am not sure where the best place is to fit the sender unit into the block? My block is the cast iron LSx, I have a Canton sump with remote oil filter so not the usual GM filter into the sump. Is there a port in the block itself?

VRSenator065

Apologies, after posting this I realised there is a 1/8" NPT auxiliary tapping in the remote filter block, I will use that.

67Skylark

The factory oil pressure port is aft of the intake on the drivers side. You would have to bye/make an adapter if it wasn't supplied with your gauge kit.