Doesn't everyone have a VRX ?
Just finished 3D printing a couple of dozen this evening.





Just kidding of course

The VRX looks so promising. I really wish it was available .

 

It looked like it really could have been promising.

 

Watch my HPR 468 build thread for some upcoming test data for said FAST

 

An earlier dyno test using a stroker 415" LS3 ......you can only guess what the LS7 will do with better heads, bigger displacement, and more RPM ;-)

;-)

 

Not a "terrible" hit down low, but doesn't do **** below 5600rpm... I'd venture a guess to say it would be great for racing. I wouldn't run it on a street car though.
That dyno is of a completely different intake though, so who knows.

 

Would like to see pics on an engine not at a trade show

 

The pTR is the FAST LSX-HR with the a carbon lid instead of the plastic nylon lid.

 

Coming soon, but to wet your appetite.....









FYI, a Holley Hi-RAM base, measured without the lid......

 

But.........I can post this

 

Lol. Like watching the cable tv **** channels scrambled.

Digging that coil set up on the valve covers though. That is cool

 

Until I get official approval, scrambled **** channel is all I can do............ but rest assured, there is "****" in that scrambled signal

 

WOW!
ET to Fire Up?

 

Trying to get a schedule for mid-May on the engine dyno
And......you just might get to see numbers for a bigger combo, one that starts with a "5"

 

Very cool, my motor wont make the power yours does, but im in for a friendly art competition...oh wait, thats dumb, more hp=winner! Lol

 

Texas Speed have a 3D printer version of a intake like the FAST and Carbon R. The guys from Complete Street Racing out of PA went to visited Texas Speed in a video below showing this new intake at the 1 min 57 sec time line. They are just testing the limit of this 3D printing intake for now and then put it on the market later.

 

I think CSP(Complete Street n Performance) is out of PA?! Those guys did a nice job workn on and tuning my Cts V. Id defly go back there for tuning when the time comes...

 

Heck yeah!

 

That's correct (rkupon1) they are from PA (My Bad). Another performance shop call (Race Proven Motorsports) is out of Delaware.

 

Performance Design have intake lid for the Holley High Ram Intake.

https://www.performancedesign.com/pr...page/carbon-hr

 

they are also making one for their version of the FAST HR too........and maybe, just maybe, an extra special test unit for my needs ;-)