Car won't start !! ZERO CODES !! Video in..
.. If it was an ignition issue, wouldn't it at least throw a code? 
I ran it a little hard last night but I don't know if that had anything to do with it, it's my car in the signature. All of the sudden it won't start now, not only that but it won't jump start either, so no spark?
Few details maybe you guys can direct me better :
No fuel problem as I can hear the pump kicking on when ignition is turned on. no battery problem. There's enough air going in, but I think it isn't sparking, correct me if you think I'm wrong after listening to the sound in the video.
Now to the Spark : I got MSD opti spark on it, and MSD ignition coil, spark plugs and wires are almost brand new so there's no problem there, but what else could cause it not to start and not even when trying to jump start it ?!
My shop is a half hour away so all my tools are down there, I thought to ask you guys, what's ur opinion?
Here's a short video of how it sounds : http://www.youtube.com/watch?v=ijEi1cLnewk
Comments and suggestions are greately appreciated.
Adam
Last edited by powerhousecamaro; Jul 4, 2009 at 02:23 PM.
After scanning for codes, I checked the schrader valve for fuel, and sure enough there was fuel.
Next, checked for spark and here's what happened :
I pulled a spark plug with the wire on the driver side and asked the wife to crank it, it STARTED. But here's the thing :
I DID NOT try to start it after checking and having some fuel shot out of the schrader valve, so I don't know if that did something to make it start. However, it started while the spark plug was out and after doing these two checks together.
After that I cranked it few times and it started 3-4 times no problem , with the plug off and then with the plug and wire back on. (Right now I'm writing you guys but will go back to see if it starts again).
What "was" the problem and how come it started now after doing these two things? Trying to find if problem solved !!!
Thanks guys.
Adam
Now it starts once out of ten times that I tried, and when it starts the first time, the 2-3 times you try after that time it starts in all of them, but then again it goes back to not starting and no spark. ******* opti isn't it ?
The last it started I kept it running for two minutes, as soon as I got in the car to drive it to my shop it started shutting of till it died, ******* opti or not?
1- Replaced Computer. NO START.
2- Replaced Coil wire. NO START.
3- Replaced Ignition Module. NO START.
4- Replaced ignition Coil. NO START.
5- Checked the two ignition sensors in relay box. NO START.
WHAT DO YOU THINK IS GOING ON GUYS, OPTI OR NOT OPTI?
Adam
Trending Topics
The Best V8 Stories One Small Block at Time
, A car that won't run, a HALF hour away from my shop where she stays most of her life, so everytime I get a new advice I have to drive an hour back and forth to come with parts to replace and see what happens. I think tonight I'll call AAA to have a flat bid and tow it to my hospital, I'll be a lot smarter down there
..Thanks for your comments guys

Adam
This is a time when you really need a Tech2/scanner. I would not own an LT1 without a good scanner. And i dont mean a code reader

Have you looked into the ignition relay?
The opti on LT1's is freaking HORRIBLE!
I know m shop sees LOTS of spark/no fire issues on LT1's all the time.
I'll give them a ring and post suggestions if you haven't figured it out by tonight.
Good luck




