S_M_I_D_D_Y

Has anybody here milled a few thou off the rocker stands on a ls3 head to get the swipe pattern looking a little prettier with a big lift cam and stock rockers? even better does any company make a lower stand that will get me out of trouble? ive done alot of searching and come up with nothing sofar.

Cheers, Mitch

Briou

iTrader: (1)

Email or call Chris Frank at Frankenstein...i'm sure he can get it done for you

KCS

iTrader: (20)

You can mill them, but the tabs on the corners have to be cut off. Not a lot of people understand/care about valvetrain geometry, so I'm not surprised a search didn't help much.

S_M_I_D_D_Y

Cheers mate im in Australia so unless there is an off the shelf part ill just take to mine with the mill n hope for the best I reckon.

CBM Motorsports

iTrader: (2)

We have done a set or two before. We don't mill the bottom side. We would cut the part that the rocker rides on. A little more work but better then getting rid of the alignment tabs.

A_VAS

iTrader: (16)

I have done it and works fine. Have also shimmed them up with Ford racing rocker pedestal shims. They fit under the stand and around the bolt nicely.