Going to put this in my TBSS and was wondering if anyone has ran this option before and if so how did they like it?

Im debating on milling the heads .015 to raise compression a bit

Mods will consist of

LY6
BTR Stage 3 Cam 229/244 .615"/.595" 113+4
Ported TB/Intake
Stainless Works Longtube Headers
Underdrive Pulley
3600 Stall

Goals - BEAT 5.0s!!!!!!

its a daily driver and i don't really care about MPG.(BECAUSE RACE SUV)

Also will 7.4 pushrods be fine?

Any help is greatly appreciated.

thank you.

 

If you mill heads, you need shorter pushrods than otherwise.
MEASURE to be sure!

 

hey I have a Ly6 I’m getting ready to cam what cam did you end up with, I want a decent na cam an next year I’m goin turbo so I don’t want to fly cut or anything

 

This is an old thread....2017

 

ok I know and was asking the op thanks

 

OP is still active here. Hopefully he might chime in....

 

thank you buddy I made a post I was just looking for someone that has used either that cam or something like tick street heat stage 2 cam. It’s going in a light fox body mustang, 4l80

 

I have the BTR Stage-3 cam in my Heads/Cam LS3 that's in my Impala.

Love it! Very strong through the entire power curve, a good bit of chop at idle, but still very streetable!

Since you asked.

KW