LS Motors - HEAD STUDS - TORQUE SPECS ???
#1
TECH Enthusiast
Thread Starter
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
QUESTION . . . When using Head Studs on an LS block ( iron LQ4, in this case ), instead of Bolts, what is the correct Torque Spec, since Head Studs don't "Torque To Yield" ?
Thanks, in advance !
Thanks, in advance !
The following users liked this post:
G Atsma (11-01-2020)
#5
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
The above is for BOLTS. Here’s the STUD instructions
https://cdn2.arp-bolts.com/instructi...lat-washer.pdf
https://arp-bolts.com/kits/instructi...?RecordID=5177
https://cdn2.arp-bolts.com/instructi...lat-washer.pdf
https://arp-bolts.com/kits/instructi...?RecordID=5177
#6
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
The above is for BOLTS. Here’s the STUD instructions
https://cdn2.arp-bolts.com/instructi...lat-washer.pdf
https://arp-bolts.com/kits/instructi...?RecordID=5177
https://cdn2.arp-bolts.com/instructi...lat-washer.pdf
https://arp-bolts.com/kits/instructi...?RecordID=5177
The following users liked this post:
Che70velle (11-03-2020)