When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm trying to make a stand alone harness. The X115 connector has a lot of wires that don't go back to the ecm. I'd really like to know what I'm dealing with before I just remove them.
lt1swap.com has a spreadsheet and details of how to convert to standalone config. gmupfitters.com has factory diagrams if you need them too. look for body builder manuals.
lt1swap.com has a spreadsheet and details of how to convert to standalone config. gmupfitters.com has factory diagrams if you need them too. look for body builder manuals.
I've got the 1256 page Upfitter PDF, it's painfully difficult going system by system that might or might not pass through that connector. After 300 pages I have 5 of the wires in that 53 pin connector. LT1 swap has up to 2014 or15 which is different. Those are good sources that you recommend and I appreciate the reply. So far they aren't much help though.
Last edited by rubrhammer; 01-23-2023 at 08:43 AM.
Reason: Additional info