ss overlays
Thread Starter
Teching In
Joined: Aug 2008
Posts: 7
Likes: 0
ss overlays i just received my black ss overlays for my 06 monte carlo ss
the side overlays fit good, but the one on the back was way too small... i also have a smaller ss logo on the front instead of the chevy logo
what are the sizes off the ss badges for the back?
i told the guy i needed 2 5 1/4" and 2 3 3/4", is this correct? because the 3 3/4s were small
the side overlays fit good, but the one on the back was way too small... i also have a smaller ss logo on the front instead of the chevy logo
what are the sizes off the ss badges for the back?
i told the guy i needed 2 5 1/4" and 2 3 3/4", is this correct? because the 3 3/4s were small
LS1Tech Sponsor
Joined: Dec 2005
Posts: 2,932
Likes: 12
From: CT
well, the SS you have on the back trunk lid, is it the same size as the ones on the doors??
the ones on the doors are the big ones, and the "standard" one that comes on the trunk is smaller than those...
the ones on the doors are the big ones, and the "standard" one that comes on the trunk is smaller than those...
__________________
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
