HUD Problem, Need Help...
HUD Problem, Need Help... Hey guys,
To make a long story short I have a problem with my HUD. It almost looks like it came off track. I think a spring may have come off or something...? I know it still works because when I tap the dash it comes back down then immediately goes right back up. Very strange, indeed... So, how do I take the HUD off. What comes off first. From the looks of it, I think the pillars come off and then? Any help would be greatly appreciated. Thanks Homeys...
-Mike
To make a long story short I have a problem with my HUD. It almost looks like it came off track. I think a spring may have come off or something...? I know it still works because when I tap the dash it comes back down then immediately goes right back up. Very strange, indeed... So, how do I take the HUD off. What comes off first. From the looks of it, I think the pillars come off and then? Any help would be greatly appreciated. Thanks Homeys...
-Mike
You might have to take the top deck of the dash off in order to gain access to the HUD. Just a thought... I have a small vibration in mine when I go over bumps. It's nothing major it's just annoying as hell 
. I might try and solve the problem this Sunday.
. I might try and solve the problem this Sunday. I did have a screw behind the cluster. I got done about half hour ago and I started at 11:00 am taking many breaks. The worst part was the sensors near the windshield. The big round one is the worst! I didn't know that the round protrusion was a cap and that dropped somewhere inside the dash. I said "oh well" looks like it is staying there. lol... I am not sure what sensor it is. It isn't the little red LED one it's the other one.
Other than that lil' mishap it wasn't too bad of a job. I didn't get a plastic washer like they said to. I took a little holder off and put the other end of the spring under that and screwed it back down. Doing it this way insures it will not break ever again. At least that piece won't... The HUD now works like it should.
On a side note; anyone know what that sensor is and where I can find another one? Thanks for all the help.
-Mike
Other than that lil' mishap it wasn't too bad of a job. I didn't get a plastic washer like they said to. I took a little holder off and put the other end of the spring under that and screwed it back down. Doing it this way insures it will not break ever again. At least that piece won't... The HUD now works like it should.
On a side note; anyone know what that sensor is and where I can find another one? Thanks for all the help.
-Mike
Last edited by Mgpeagle; Jul 30, 2010 at 01:30 PM.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
