Traction Control Issue
#1
On The Tree
Thread Starter
Join Date: May 2009
Location: Aurora, IL
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
My traction control light has been coming on briefly when I first apply light throttle from a stop...No, the tires are not spinning, but I can hear the traction control system activate briefly as the light comes on.
Important note = I have a Diablew tune on the car that disables the traction control system. I have had this tune for over a year, but the issue has only been happening for a few months.
Again, light throttle from a stop, no tire spin...any ideas?
Important note = I have a Diablew tune on the car that disables the traction control system. I have had this tune for over a year, but the issue has only been happening for a few months.
Again, light throttle from a stop, no tire spin...any ideas?
#3
On The Tree
Thread Starter
Join Date: May 2009
Location: Aurora, IL
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Yes, the tires were quite worn, but I actually just got 4 new tires installed today and the same problem is there. Happening at almost every stop/go.
New wheel bearings perhaps?
New wheel bearings perhaps?
#4
Teching In
Join Date: Oct 2010
Location: Lorette Manitoba
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Check also for a break in the wire harness going to your front wheel bearings. I had a break and was able to splice a new piece of wire in the harness. A break would likely be close to the hub where it gets a lot of flexing (10-16" from hub)
I would also check and clean the connectors for the hubs.
Someone here had posted a while back how to check with an ohm meter but not sure who or what the readings should be.
I would also check and clean the connectors for the hubs.
Someone here had posted a while back how to check with an ohm meter but not sure who or what the readings should be.