C6 C6Z Kooks 3" X 3" catted X-pipe w/ sensor bungs
#1
On The Tree
Thread Starter
iTrader: (10)
Join Date: May 2006
Location: Boulder Bubble, Colorado
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
C6 C6Z Kooks 3" X 3" catted X-pipe w/ sensor bungs
SOLD!!!This work of art came with my Kooks Race stepped race headers for my C6Z. I don't have to pass emissions where I live so I ordered up the front half of the cat-less X-pipe for my car.
This part has been sitting since last August all boxed up. It has been installed and run for a couple hundred miles ( while I awaited my offroad section)
This is the 3" in and 3" out metal matrix high flow catalytic converter version. It has (2) O2 bungs installed AFTER the cats. Just unbolt your current Kooks mid pipe, slide this in, re-use your existing band clamps and you are set to go! You can save your existing front half section and swap it in an out as you desire.
Kooks part# 6611S retail $845
$500 gets it shipped Fed EX to your front door ( or office if you prefer). I DO accept paypal.
This part has been sitting since last August all boxed up. It has been installed and run for a couple hundred miles ( while I awaited my offroad section)
This is the 3" in and 3" out metal matrix high flow catalytic converter version. It has (2) O2 bungs installed AFTER the cats. Just unbolt your current Kooks mid pipe, slide this in, re-use your existing band clamps and you are set to go! You can save your existing front half section and swap it in an out as you desire.
Kooks part# 6611S retail $845
$500 gets it shipped Fed EX to your front door ( or office if you prefer). I DO accept paypal.
Last edited by bowtiguy; 02-16-2009 at 04:17 PM.
#2
On The Tree
Thread Starter
iTrader: (10)
Join Date: May 2006
Location: Boulder Bubble, Colorado
Posts: 169
Likes: 0
Received 0 Likes
on
0 Posts
To answer some PM's I got recently..
I know this X-pipe will bolt up to ALL C6 Kooks headers..every other header manufacturer I can't guarantee.
You CAN bolt up just about ANY C6 rear exhaust system to the kooks intermediate pipes ( cats or cat free) as they are designed to end where the stock system does. On C6Z's this would be 3", C6 are 2.5" so you can actually upgrade to a complete 3" exhaust on standard C6 cars.
Hope that helps!
I know this X-pipe will bolt up to ALL C6 Kooks headers..every other header manufacturer I can't guarantee.
You CAN bolt up just about ANY C6 rear exhaust system to the kooks intermediate pipes ( cats or cat free) as they are designed to end where the stock system does. On C6Z's this would be 3", C6 are 2.5" so you can actually upgrade to a complete 3" exhaust on standard C6 cars.
Hope that helps!