faust.dr

iTrader: (1)

Price: $1250 (about $700 less than new)

This is a really great system that has been on a display vehicle. It was purchased from MSD, however since then Painless Performance has acquired the product and is selling it under their brand.

This is the fully programmable kit that comes with the laptop software and license for use with the included ECM.

The sweetest thing about this system is that the harness is designed to plug directly into the OEM sensors. It shine for tuning engines with large cams since it is a Speed Density system. If you have a stock engine the software already come with the factory tunes so all that's required it to upload the tune for your engine and you are ready to start it up.

Here is what you get:

MSD Part Number 240020

- Delphi MEFI ECM
- Complete engine harness to use with LS2 or LS7 (58X) crank wheel
- Fuel injector harness for LS2/LS7 injectors (42 lb/hr)
- InGenius Programing software
- Cable to connect ECM to your laptop

Here are some of the details:

* Closed loop idle/air speed control functionality (you would need an NGK AFX wideband O2 kit for this)
* Uses GM MAP, TPS, coolant sensors
* Speed-density algorithms allow for easy tuning
* Drives eight high impedance injectors
* Advanced transient fueling algorithms
* Seamless decel fuel cut-off
* Compatible with 1 and 2 BAR MAP sensors


I also have the Racepak dash available for an extra $850 dollars. It's a special version of the UDX dash (UDX-EFI) that reads sensor data directly from the ECM through the CAN bus. It will display any engine parameter including the Air/fuel ratios if you have the wideband hooked up.

You can post to the thread or PM me with questions.

Thanks!

faust.dr

iTrader: (1)

The details and pricing has been updated.