Custom Exhaust
05-07-2005, 01:46 AM
#1
Custom Exhaust I bought this exhaust last week. I also won another one, so one has to go! orignally a Flowmaster 40 series 3" catback with the single 3" outlet, all mandrel bent.
Then I had my cousing (a machinist) cut me some thick 3 bolt flanges. I made a cutout copying the Borla setup. I had another talipipe bent and put a 3 bolt header flange on it and at the other side of the cutout.
The tips are 4" round polished stainless steel with an angled cut at the end and a rolled lip. The tips were $70 new.
It has everything but the intermediate pipe. The over axle pipe is also 3". So all you need is to use your factory I pipe, or it would be easy for a shop to make one.
pics appon request.
Then I had my cousing (a machinist) cut me some thick 3 bolt flanges. I made a cutout copying the Borla setup. I had another talipipe bent and put a 3 bolt header flange on it and at the other side of the cutout.
The tips are 4" round polished stainless steel with an angled cut at the end and a rolled lip. The tips were $70 new.
It has everything but the intermediate pipe. The over axle pipe is also 3". So all you need is to use your factory I pipe, or it would be easy for a shop to make one.
pics appon request.
