LS6 Heads!!!! race/street!! CNC
08-17-2005 | 08:28 PM
#1
Thread Starter
8 second mod
iTrader: (37)
Joined: Nov 2002
Posts: 17,879
Likes: 1
From: East Side Performance! mASShole
LS6 Heads!!!! race/street!! CNC I have my old heads, ls6 done by CNC. new rev springs, just need to be cleaned (sitting for a couple months) some carb cleaner and an air gun.
springs are still strong, the heads where run for 1 pass since they where freshed, and probably 500 street miles with my small cam under 600 lift
the heads where $1,000 core, $3k from CNC (he did a CNC on them, then hand ported and polished everything, Sweet Heads!) then i put anothe 500 into haveing them freshend and re cut ect ect.
these heads on a stock block will be about 12-1 CR. with a smaller cam should fit P to V clerance.
with these heads, a small cam, nitros motor, th-400 set up for spray, ect ect put over 400 to the ground, and went 9.6 on spray.
they are a great set of heads.
i had them promised to someone, but he hasnt got back to me, and i need the cash.
any interest? i'd like to get $2300 let me know
springs are still strong, the heads where run for 1 pass since they where freshed, and probably 500 street miles with my small cam under 600 lift
the heads where $1,000 core, $3k from CNC (he did a CNC on them, then hand ported and polished everything, Sweet Heads!) then i put anothe 500 into haveing them freshend and re cut ect ect.
these heads on a stock block will be about 12-1 CR. with a smaller cam should fit P to V clerance.
with these heads, a small cam, nitros motor, th-400 set up for spray, ect ect put over 400 to the ground, and went 9.6 on spray.
they are a great set of heads.
i had them promised to someone, but he hasnt got back to me, and i need the cash.
any interest? i'd like to get $2300 let me know