Hello,
I have a very fresh 6.0 block in a storage bag on an engine stand. It has 90% of the machine work already done. It was bored and honed .030" over, washed, new freeze plugs,and new federal mogul race series camshaft bearings installed. It only needs a line hone on the mains and it's ready to rock. I started the project for a 408 I was going to build, but i got an amazing deal on a darton sleeved 4.125" aluminum block so I stopped the iron block. The machine work was $245.00 and i paid $500.00 for the block shipped. I will get rid of it for $500.00 plus shipping..so the machine work will basicly be free. Let me know if your interested. I also have matching diamond flat top 4.030 pistons and rings. I will let both go for $1100.00 plus shipping. Thanks.

Carter

 

Did you pick up that block that was on ebay? I was lookin at that one, didn't know how much it went for though. Looked like it had some flash rust in the cylinders, but other than that... perfect. Good luck selling your parts, wish I could afford all of it! =)

 

interested in the block depending on where u are in florida might pick it up

 

pm sent

 

block is sold!

Carter