Moser Aluminum Center Section
#1
Moser Aluminum Center Section
For 9 inch rear. Loaded with 4.11 ratio gears and Trac Loc posi. 32,050 miles, perfect condition. Never drag raced; used for AutoX and street duty. Fluid changed every 10,00 miles. I replaced it with 3.50 gears more suitable for road racing.
This aluninum design uses through-bolts to retain the bearing caps, so it is very strong and well suited for drag racing. Makes a 9 inch rear only 15 lbs heavier than the stock axle. Will fit any 9 inch rear with 31 spline axle shafts.
In reusable plastic carrier case and ready to send to your address for $875 shipped. I will accept money order or cashiers check.
This aluninum design uses through-bolts to retain the bearing caps, so it is very strong and well suited for drag racing. Makes a 9 inch rear only 15 lbs heavier than the stock axle. Will fit any 9 inch rear with 31 spline axle shafts.
In reusable plastic carrier case and ready to send to your address for $875 shipped. I will accept money order or cashiers check.
Last edited by Cal; 05-13-2006 at 01:19 PM.