Ported TB for sale
Thread Starter
Joined: Oct 2004
Posts: 2,357
Likes: 0
From: Vance, Alabama
Ported TB for sale I have a 00-04 Fbody ported TB for sale, $150 shipped in the 48 states. Looks like this:
I have a 98-99 Fbody ported TB for sale, $150 shipped in the 48 states. Looks like the one in the pic but with the 98-99 throttle shaft.
I take money orders and paypal.
I have a 98-99 Fbody ported TB for sale, $150 shipped in the 48 states. Looks like the one in the pic but with the 98-99 throttle shaft.
I take money orders and paypal.
Thread Starter
Joined: Oct 2004
Posts: 2,357
Likes: 0
From: Vance, Alabama
Thanx, mods are:
Throttle stop mod
Half shaft mod
Fully ported housing
Thinned and trued blade
flipped idle screw
NEW grade 8 blade screws and washers(Ive always used washers, one of my "trademarks")
As most know,I have R&Ded TBs more than anyone(which is why most of the fastest and highest HP bolt on cars have one of mine) and epoxy does nothing at the dyno or track neither does knife edging. I have always trued the blade since they are stamped from the factory and are warped(some pretty bad) so in return it is thinned to roughly .075". I have always used washers under the screws because the factory screws are tappered to fit the throttle shaft and when you cut that out for more airflow it takes that away and spreads the aluminum blade holes and I have seen them start to crack the blade from some that Ive seen done by other people in the past(I then have to repair/replace the blade when I redo the TB). I now use new grade 8 blade screws because I have a supplier that carrys them.
Throttle stop mod
Half shaft mod
Fully ported housing
Thinned and trued blade
flipped idle screw
NEW grade 8 blade screws and washers(Ive always used washers, one of my "trademarks")
As most know,I have R&Ded TBs more than anyone(which is why most of the fastest and highest HP bolt on cars have one of mine) and epoxy does nothing at the dyno or track neither does knife edging. I have always trued the blade since they are stamped from the factory and are warped(some pretty bad) so in return it is thinned to roughly .075". I have always used washers under the screws because the factory screws are tappered to fit the throttle shaft and when you cut that out for more airflow it takes that away and spreads the aluminum blade holes and I have seen them start to crack the blade from some that Ive seen done by other people in the past(I then have to repair/replace the blade when I redo the TB). I now use new grade 8 blade screws because I have a supplier that carrys them.
I'll take it if the guy in Hawaii doesn't. I can Paypal you the money later today, just got to get to the bank first. LMK asap!
I want the '00-'04 BTW Thanks-
PM your paypal addy when/if Ready...
I want the '00-'04 BTW Thanks-
PM your paypal addy when/if Ready...
