FS: Custom Madman/Pinto manual rack style steering shaft
#1
TECH Resident
Thread Starter
iTrader: (46)
Join Date: Dec 2001
Location: Some where in the Corn Fields of Illinois
Posts: 821
Likes: 0
Received 0 Likes
on
0 Posts
FS: Custom Madman/Pinto manual rack style steering shaft
I have a custom steering shaft for a Madman/Pinto/Wilwood manual style steering rack. I ended up going with a different setup and I no longer need this shaft. To build a shaft like this your looking at over $200 with the joints and chrome moly shaft.
I'll let it go for $100 shipped.
I accept paypal or money orders.
Email is smknta95@hotmail.com
I'll let it go for $100 shipped.
I accept paypal or money orders.
Email is smknta95@hotmail.com
#2
On The Tree
iTrader: (44)
Join Date: May 2004
Location: Tuscaloosa AL
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Is there ANY slack when this is slid onto the Column stub? The one I currently run has a little wiggle room and is quite annoying. The play I am concerned about is 90degrees from the bolt hole.....if that makes sense.
#3
TECH Resident
Thread Starter
iTrader: (46)
Join Date: Dec 2001
Location: Some where in the Corn Fields of Illinois
Posts: 821
Likes: 0
Received 0 Likes
on
0 Posts
No, there isnt any slop, movement or wiggle room when the shaft is slid over the steering column stub. It fits very nicelly. I sent you a PM also.