parting out 2002 camaro z28
#124
Staging Lane
iTrader: (13)
Join Date: Oct 2003
Location: Austin Tx
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
ok spare tire and the bolt that holds it in place...dont need the jack, rear panels with the speaker covers and the privace flap that hides the ttop storage. also I need 1 of the child seat holders that is on the deck and the bolt.
#130
TECH Apprentice
iTrader: (11)
Join Date: Nov 2001
Location: Granada Hills, CA
Posts: 331
Likes: 0
Received 0 Likes
on
0 Posts
What condition is the carpet in? I just need the front section, not the trunk section. Price shipped to 91344?
I also needed both interior kick panels. Price?
And lastly how about the fiberglass front bumper support (that grey piece near the hood latch)?
Thanks!
I also needed both interior kick panels. Price?
And lastly how about the fiberglass front bumper support (that grey piece near the hood latch)?
Thanks!
#132
TECH Senior Member
iTrader: (28)
Is this damaged? price?
https://ls1tech.com/forums/showth...02#post8070502
Also the lower black plastic half of the radatior duct.
thanks
https://ls1tech.com/forums/showth...02#post8070502
Also the lower black plastic half of the radatior duct.
thanks
#133
Launching!
Thread Starter
iTrader: (49)
Join Date: Feb 2004
Location: Davenport, IA
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
I have a very nice low mile ebony carpet for 110 shipped
No radiator parts
Which headlight?
I don't have anything along those lines right now green. You did get the hoses didn't you?
No radiator parts
Which headlight?
I don't have anything along those lines right now green. You did get the hoses didn't you?
#135
how much for dash trim plastic that goes around stereo and the little ones around both side vents plus the plastic trim behind the door handles and also the console trim (for man. trans) shipped to 33811. reply via pm.
#136
TECH Senior Member
iTrader: (28)
opps my link didn't work. this should, I need both the parts I listed,
https://ls1tech.com/forums/showthrea...t=#post8077426
https://ls1tech.com/forums/showthrea...t=#post8077426