C6 APS TT kit for sale
10-23-2007, 04:22 PM
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Oct 2005
Location: Poughkeepsie, NY
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
C6 APS TT kit for sale For Sale C6 APS Twin Turbo Kit
http://www.airpowersystems.com/corvette/c6.htm
This kit was installed in Sept and has approximately 500 miles on it.
I am in the process of selling the car and the potential new owner does not want the turbos on the car. So I am removing the kit now.
Final dyno tuning was not completed. Preliminary pulls at 9psi yielded 520 ft.lbs. @ 3600 rpm!
This kit is complete, ALL hardware, clamps, hoses, complete instructions ( less the clutch line extension hose). This is a flex line with compression fittings that can be easily fabricated. I personally think if the clutch line is covered with a heat wrap this may not be needed.
Also included, that were not in the APS kit:
· A set a fuel injector harness adaptors. Just “plug and play” no cutting of the injector harness.
· A manual boost valve and a 2 step boost controller. As shown here: http://www.boostvalve.com/pricelist.html ($149.00)
· I will also include the C6 inner fender wells that have already been cut. No need to cut yours.
This kit MSRP sell for $8500, plus ~$500 shipping. I am selling for $5500 shipped U.S. Only. updated 10/25
PM for details.
http://www.airpowersystems.com/corvette/c6.htm
This kit was installed in Sept and has approximately 500 miles on it.
I am in the process of selling the car and the potential new owner does not want the turbos on the car. So I am removing the kit now.
Final dyno tuning was not completed. Preliminary pulls at 9psi yielded 520 ft.lbs. @ 3600 rpm!
This kit is complete, ALL hardware, clamps, hoses, complete instructions ( less the clutch line extension hose). This is a flex line with compression fittings that can be easily fabricated. I personally think if the clutch line is covered with a heat wrap this may not be needed.
Also included, that were not in the APS kit:
· A set a fuel injector harness adaptors. Just “plug and play” no cutting of the injector harness.
· A manual boost valve and a 2 step boost controller. As shown here: http://www.boostvalve.com/pricelist.html ($149.00)
· I will also include the C6 inner fender wells that have already been cut. No need to cut yours.
This kit MSRP sell for $8500, plus ~$500 shipping. I am selling for $5500 shipped U.S. Only. updated 10/25
PM for details.
Last edited by Dutchesscamaro; 10-25-2007 at 05:20 PM. Reason: shipping/msrp
