Parts for Sale!!! About to be crushed!! 00 T/A!
do you have any pics 
09-09-2008, 05:29 PM
#65
12 Second Club
Thread Starter
iTrader: (12)
Join Date: Aug 2004
Location: Dallas, TX
Posts: 402
Likes: 0
Received 0 Likes
on
0 Posts
bumper As stated in the original post it was damaged in the wreck but I do have the front bumper support if you need that as well. also have airbag equipment. I appreciate you looking and inquiring.
-Scott
-Scott
Last edited by linegtdt52; 09-13-2008 at 08:13 AM.
09-29-2008, 06:29 PM
#74
12 Second Club
Thread Starter
iTrader: (12)
Join Date: Aug 2004
Location: Dallas, TX
Posts: 402
Likes: 0
Received 0 Likes
on
0 Posts
Guys car is going to crushed next week. Just pulled the motor yesterday. Got torque arm, driveshaft, tubular lower control arms, True dual x-piped dynomax bullet mufflers ready to go. All ready to be shipped out within 48 hours. Also got computer, (2) 17" aluminum TA wheels, spoiler (not hatch), side view mirrors, radiator, condenser, cooling fans, steering wheel, passenger side airbag, RED stock Trans Am hood (8 out of 10 condition), leather passenger side seat and rear seats all ready to go. That should be it
09-29-2008, 07:17 PM
#75
I need a couple pieces that are basicaly worthless to anybody else but would help me out a lot. I need the the two rear saybar endlink mounts (that bolt to the body...I would like to get the 2 bolts off each side too) and there is a bracket on the drivers side swaybar mount (the round bushing mount) that is attached to the outside of the frame rail with two 10mm bolts and to he front (possilbly the back) swaybar busing bolt. Its about 6in long.
Also I could use the Spindle Arms in the front...just the arms. I dont need the hubs, you could sell them to somebody else.
I want to get those pieces chromed but dont want my car to be down for a month while they are off. What would you change me for those shipped to south GA (31763)?
This is a pic of the pieces I need off the rear...the piece bolted to the car with the endlink sticking through it:
This is a pic of the front pieces...the spindle arms and that brace/bracket just over the top of the sway bar bracket:
Also I could use the Spindle Arms in the front...just the arms. I dont need the hubs, you could sell them to somebody else.
I want to get those pieces chromed but dont want my car to be down for a month while they are off. What would you change me for those shipped to south GA (31763)?
This is a pic of the pieces I need off the rear...the piece bolted to the car with the endlink sticking through it:
This is a pic of the front pieces...the spindle arms and that brace/bracket just over the top of the sway bar bracket:
