LS1TECH - Camaro and Firebird Forum Discussion
SBC-BBC-LT1-LT4 PERFORMANCE
LT1-LT4 Modifications
Almost done replacing opti... BUT...

LT1-LT4 Modifications 1993-97 Gen II Small Block V8

Almost done replacing opti... BUT...

Reply Subscribe

Search this Thread

Old

Nov 14, 2008 | 07:40 PM

#1

Thread Starter

Staging Lane

Joined: Dec 2007

Posts: 76

Likes: 0

From: west palm beach, fl

Default

Almost done replacing opti... BUT...

I took these pictures, sorry for the poor quality but its dark and it was on my phone. Anyway, i have my new opti on with the pin lined up and it slid on fine. the problen is that the bolt holes for the opti are still about a 16th or an inch or so away from bolting up perfectly. is this normal, should i just bolt it up and it'll be fine or should i keep messing with it???

Old

Nov 14, 2008 | 07:58 PM

#2

Thread Starter

Staging Lane

Joined: Dec 2007

Posts: 76

Likes: 0

From: west palm beach, fl

Default

anyone?
i have to get it out of the parking lot...

Old

Nov 14, 2008 | 09:08 PM

#3

Launching!

Joined: Dec 2003

Posts: 260

Likes: 0

From: Palm Bay, Florida

Default

When I changed the opti on my Impala is was flush.

Old

Nov 14, 2008 | 10:08 PM

#4

TECH Junkie

iTrader: (12)

Joined: Sep 2007

Posts: 3,011

Likes: 0

From: SFL

Default

You probably didn't put it in the right hole, so to speak

Take it out and make SURE it's on right.

Old

Nov 14, 2008 | 10:16 PM

#5

Thread Starter

Staging Lane

Joined: Dec 2007

Posts: 76

Likes: 0

From: west palm beach, fl

Default

thanks for the replies! it was on the right hole. it was just the crank hub hitting it on the bottom... duh!

Reply Subscribe

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 07:12 AM.